Users Manual Part 2
12 - 4 Operator’s Manual
12 Service
Identification rules:
– A beep sound occurs if the reagent information is successfully identified.
– Three beep sounds occur if there is a mismatch between the RFID card and the reagent.
NOTE:
• The current system date is set as the open date of the reagent if the reagent information
is successfully identified for the first time.
• A RFID card can only be used for once.
• When you are entering an expired reagent, the analyzer will prompt you to check
whether the reagent is expired.
• When multiple reagents need to be replaced, swipe RFID cards for these reagent and
perform the next steps.
Install new reagent
NOTE:
When installing new reagents, make sure the color of reagent cap assembly is the same as the color
in the rectangle box in reagent label.
Replace dye
Follow below instructions:
1. Open the dye compartment door.
2. Get a new dye bag, open the cap and the aluminum film sealing the bag.
3. Take out the bag to be replaced along the direction of the supporting rack.
4. Turn the cap of the old reagent container counterclockwise, and then take out the cap assembly
with caution.
NOTE:
If the pickup tube of the cap assembly is stuck when it is taken out of the dye bag, slightly
adjust the position of the pickup tube and then take it out without pulling by force.
5. Insert the pickup tube of the cap assembly vertically into the new container, and then turn the
cap clockwise until it is secured.
NOTE:
During replacement, make sure that the pickup tube of the cap assembly does not reach the
bottom of the reagent bag, otherwise the reagent cannot be aspirated normally.
6. Put the sealed new bag back on the support rack, making sure the bag is securely
accommodated.
7. Cap the old bag using the cap of the new bag and dispose of the old bag properly.
Replacing other reagent
Follow below instructions:
1. Remove the cap of a new reagent container, and place the container next to the one to be
replaced.
2. Turn the cap of the old container counterclockwise, and then take out the cap assembly with
caution.