User's Manual

User Manual
A. Connect and disconnect with Bluetooth devices
NOTE: One bulb can only be connected to one Bluetooth device(output sound).
1. Connect:
Turn on the Bluetooth device, search available devices ”Speaker BEST L2” and connect. When you hear
dual prompt tone that means connect successfully.
2. Disconnect:
Turn off the Bluetooth device. When you hear one prompt tone that means connect cancelled.
B. The function of remote controller
NOTE: The LED blub has already been paired with the supplied remote controller.
One remote can control multiple LED blubs after successfully pairing.
1. Put the music bulb to the lamp holder and turn on, you will see the white light when you hear one
prompt tone.
2. If you need to change colors, please turn off the light and turn it on again within 3 seconds at the
first time, the color will flash randomly.
3. Turn off the light via remote control, and the Bluetooth function is still working, which means you
can still enjoy music.
4. When you turn it on again, it will show the light in last color. If you cut down the power and turn on,
the light is still white light.
C. Modes of Remote Control
1. 15 colors and white color.
2. Four modes: flash mode, strobe mode, fade mode and smooth mode.
3. Adjustable brightness with extra 4 levels.
4. Turn on and turn off the music bulb.
D. Music bulb parameters
Cautions:
1. Do not put the bulb and remote into fire.
2. Please turn off the power when not in use.
3. Please try to install it far away from wires devices, high-power electrical appliances, wall
corners or other obstacle to reduce the influence of signal transmission distance.
Project
Specification and description
Input voltage
AC 100-240V/50Hz-60Hz
Total power
12W
LED power
6W
Speaker power
3W
Frequency response
135Hz-15KHz
Wireless version
3.0
Support configuration
A2DP
Radio range
10m [33ft]
LED light color
White or Warm color
Cap base
E27 or B22
The two section switch
Switching between the white and colored
The weight of the light
250g