Instruction Manual

1.
a.
b.
c.
*
MADE IN CHINA
INSTRUCTIONS:
Charging Mobile Devices:
Ensure that your phone supports
wireless charging. It will be listed in the
the last page of this manual).
Connect the wireless charging pad to with
the UL listed USB adapter and provided cable.
Once
connected LED Indicator will glow RED
and the panel will light up.
Place the enabled device on the surface
of the wireless charging pad. The LED will
turn GREEN to indicate that the phone
is charging.
Note: To charge devices, use only the
accessory cable or the cable included with
your own device by the manufacturer.
The logo would light up during charging.
Radiant Light Up Logo
Wireless Charging Pad
Instruction Manual
7141-69
1 x Wireless Charging Pad
1 x USB to Micro-USB Cable
1 x Instruction Manual
Input power: 5V/1.5A
Output power: 5W/1A
1.
2.
3.
•
•
Charging Pad Surface
LED Indicator
Micro-USB Input Port
What’s included:
Features:
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F (0°C) or above
115°F (45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
•
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above the
Do not use the device if damaged or
explosion or risk of injury.
Do not disassemble the device. For repairs,
Incorrect reassembly may result in a risk of
or temperatures above 104°F (40°C) may
result in explosion.
To ensure product safety, ensure that
identical replacement parts.
Attachments on the back of your phone can
impede the effectiveness of the wireless
charger
and lead to overheating.
Please remove attachments from the phone
before charging on this device.
SAFETY PRECAUTIONS:
Read all the instructions before using the
product.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
inaccordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum 20cm distance between the
radiator your body: Use only the supplied antenna