MTO-WA718N-A1 Wireless AP U nR eg is te re d Quick Installation Guide VER ： 1.
Federal Communications Commission (FCC) Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device should be installed and operated with a minimum distance of 20 cm between the antenna and all persons.
1． Hardware connections: eg is te re d Matching the power adapter into MTO-WA718N-A1 the power outlet, computers can be connected through a network cable or wireless device.
2. Application model Wireless access point AP Mode Will end the network cable to ＷＴＯ－ＷＡ７１８Ｎ－Ａ１the network port, connected to a switch or router at the other end; WTO-WA718N-A1 as a complement to wired local area network, implementation of wired LAN wireless access. d As long as connected to the power supply, insert and attach the network cable, and then connect the computer wirelessly after simple settings WTO-WA718N-A1 to the Internet.
d re U nR eg is te 3). Wireless connection after IE address bar enter AP initial address “http://192.168.1.1” , user name and password is “Admin”; Login WEB management interface , such as: 4). In the WEB management interface for LAN Interface set to corresponding to the front of the IP address “192.168.8.
d U nR eg is te re 5). In the WEB management interface for Wireless Basic can change SSID “WR-11N” , change the channel, click on the “Apply Changes” , restart later ; 6).
d re U nR eg is te 7). Click the computer icon in the lower right corner of the wireless network, open " wireless network connection " interface, refresh network list, found " WR-11n" has enabled security of wireless network, click " Add to Profile" , in pop-up interface of "network key" within type new set of password, confirmed password, connection OK , you of personal security wireless network can using has.
re te is eg nR U d
Appendix-frequently asked questions: 1 、 Wireless signal under the influence of factors? 1) Family spaces are crowded, there is not enough space open, where walls are the most important obstacles in the room. As wireless local area network using a wireless microwave frequency band. Microwave is the greatest feature of a near-straight lines, diffraction from a very weak, so embedded in the barrier behind wireless receiving equipment will receive very weak signal, or did not receive the signal.
2) Modify the channels, reduce Wireless interference. Note: when you set up your own wireless signal transmission channel also to try to leave wireless signal channel 5 more. 3) Home electrical interference reduction, ensuring the signals clear. Place the wireless AP as possible when away from the equipment. 3, And forget your security password device configuration, network card cannot connect to the device, what should I do? At this time restore the factory parameters.
