User's Manual
Table Of Contents
- MTO-WA718N-A1 AP
- Quick Installation Guide
- VER ： 1.0
- Set your computer's IP 192.168.0.X network segment; (X is 1-253 integer between and not 60)
- With a network cable to connect the computer's Ethernet port and network interface module;
- Then the computer's command prompt window, enter ping command; has the following screen is connected properly;
- In the computer's browser address bar enter 192.168.0.60; enters the AP management interface;
- Note: It is a user-specified functions of the software; The AP default mode is Bridge, Wireless mode is Client; User name and password is admin;
- In this position, the IP address of the LAN can be modified;
- In this position you can modify parameters related to wireless;
- In this position, you can set the wireless encryption;
1． Module Interface Description:
① Antenna
② Power (Power Input DC5V to 12V)
③ V3.3V、RX、 GND、TX（The order from top to bottom）
④ LAN
⑤ Reset
⑥ Indicator(WPS、Wi-Fi、SYS、LAN、PWR)（The order from top to bottom）
After the connection is complete, Check that the LED is correctly:
LED
LED State
Description
POWER
Light
Power status normal
SYS
Light
Start when the system power-on light
LAN
Light
Wired network connectivity
WLAN
Light
Wireless network boot
WPS
Light
One-click encryption started
If the LED is not lit or not properly, check that the connection is correct.