User's Manual

4.1 LAN Interface Setup

You can configure the parameters for local area network which connects to the LAN

port of your Access Point.Here you may change the setting for IP address,subnet

mask,DHCP,etc..

Note:

a. If you change the IP Address of LAN, you must use the new IP Address to login the

router and you must change the DHCP Client Range at the same time.

b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of

the DHCP server will not take effect, until they are re-configured.

c. If the new LAN IP Address you set is not in the same subnet, the Virtual Server and

DMZ Host will change accordingly at the same time.

Click the "Show Client" button,you can see the active DHCP client table.

4.2 WAN Interface Setup

You can configure the parameters for Internet network which connects to the WAN port

of your Access Point.

a. If you choose Static IP, you should have fixed IP Parameters specified by your ISP.