User's Manual

3
LEDS Description
The Router's LEDs are located on the front panel(View from left to right).
Name Status Indication
Off No Power
PWR
On Power on
Off The Router has an error
On The Router is initializing
Status
Flashing The Router is working properly
Off The Wireless function is disabled
WLAN
Flashing The Wireless function is enabled
Off There is no device linked to the corresponding port
On
There are devices linked to the corresponding ports but no
data transmitted or received.
WAN/LAN(1~4)
Flashing Sending or receiving data over corresponding port
Reset Button
There are two ways to reset the router's factory defaults:
1) Use the Factory Defaults function on Management -> Save/Relo ad Settings page in
the router's Web-based Utility.
2) Use the Factory Default Reset button: With the router powere d on, use a pin to press
and hold the Reset button(about 5 seconds) until the SYS LED becomes quick-flash
from slow-flash. And then release the button and wait the route r to reboot to its factory
default settings.
Configuring the Router
In the IE browser,type "192.168.1.1" into the login screen.
Enter you username and password,the default username is "admin",and the default
password is "admin".
After your successful login,you can see the interface as follows: