User's Manual

Tips
 Make sure the mouse zapper is within the Z-wave network.
 Do not put the mouse zapper cover in the water,so as not to damage the mouse
zapper. The main body and the food box of the mouse zapper can be
disassembled for cleaning.
 When the mouse zapper cover is removed, the safety switch is opened ,and the
mouse zapper will not be triggered,so the mouse zapper will not output high
voltage.
 After the mouse zapper is triggered, we must turn off the power switch of the
mouse zapper,and then turn on the power switch of the mouse zapper, so the
mouse zapper can be triggered again; otherwise the mouse zapper will not be
triggered.
 Association allows for direct communication between Z-Wave network devices.
Main controller does not take part in such communication. Using this mechanism,
mouse zapper may communicate with other devices even when the main
controller is damaged.
Associations
This has the effect that when the sensor is triggered, all devices associated with the
sensor will receive the relevant reports. Through an association the sensor may
control another Z-Wave network device, e.g. the alarm device, wall plug, lamp etc.
This Sensor supports two association groups.
Association group 1 is assigned the status of the device status - send the BASIC SET
control frame to the associated to the associated devices when the probe had detected
water.
Association group 2 reports relay's status to just one device, Z-Wave network's main
controller by default. It's not recommended to modify settings of this association
group.
NOTE
Association allows for direct communication between Z-Wave network devices. Main
controller does not take part in such communication.