User's Manual

Restore the Sensor (mouse zapper) to Factory Default Settings
Reset procedure will delete all information on the Z-Wave network and Z-Wave
controller, and restore the sensor to factory default settings.
1. Remove the device cover.
2. Make sure the mouse zapper is connected to power.
3. Press the reset button for 10 seconds, LED diode will flash.
4. Release the button.
NOTE
When the mouse zapper is being restored factory settings, please make sure power
source is connected.
The status of the LED light
1.When the mouse zapper is triggered,the LED light will keep on for 1minute at
first,and then the LED light will flash for 3 minutes.
2.When the power switch on, the LED light will flash red for 5 times within the 2
seconds.
3. Quickly, triple click the code button, LED light will flash red for 5 times within 2
seconds.
4.The mouse zapper will be awakened every 4 minutes, the LED will flash red 5 times
within the 2 seconds.
5.In normal condition, the LED light keeps being out.
Battery Usage Tips
1.Battery Alarm Notification Type
When Battery voltage drops to some certain volts, the high voltage cannot kill rat. The device will
send notification to controller to remind user replace battery. This Notification supports 3 events
as follows:
1.1 Battery Energy Sufficient
Notification Type: Power management (0x08)
Event: Previous Events Cleared (0x00)
1.2 Battery Energy Not Sufficient but can kill rat 2 or 3 times
Notification Type: Power management (0x08)
Event: Replace Battery Soon (0x0A)
1.3 Battery Energy Dead
Notification Type: Power management (0x08)