User's Manual

Product Configuration
Product List
 Power plug 1pc
 Instruction manual 1pc
Including Sensor (Power plug) to Z-Wave Network
The Power plug can be added to the Z-Wave network by pressing the code button.
1) Plug the power plug in the socket. Make sure the device is located within the direct
range of the main controller.
2) Set the main controller to the learning mode (see main controller’s operating
manual).
3) Quickly, triple click the code button, the device will enter inclusion mode, and the
LED light will flash on and off with green alternately five times within 2 seconds.
4) Power plug will be detected and added to the Z-Wave network.
5) Wait for the main controller to configure the sensor.
Excluding Sensor (Power Plug) from Z-Wave Network
1) Make sure the sensor is connected to power source.
2) Set the main controller to the learning mode (see main controller’s operating
manual)
3) Quickly, triple click the code button
4) Wait for the main controller to delete the sensor
5) If the sensor has been deleted from the Z-wave network, the LED light will flash
five times within 2 seconds
Illustration
The code button
Jack
LED