User's Manual

Available Settings: 1 – 16 (Ampere).
Default Setting: 13(A).
4. Configure maximum Alarm current
This parameter defines maximum current, if the current plug provide to load great
than this parameter, the plug will send over-current notification to main controller and
the LED will be turn RED, but plug cannot cut-off power. This value must be less
than parameter 3#.
Function: Set Alarm upper current threshold.
Parameter Number: 4.
Parameter Size: 1 Byte
Available Settings： 1 – Parameter #3 (Ampere).
Default Setting: 12(A).
5. Led Display Enable
This parameter defines the LED indication Function ON/OFF. This parameter can be
configured with 0 or 1, where 0 means disable LED indication Function and will
always be turn-off, and 1 means enable LED Function.
Function: LED Enable/Disable
Parameter Number: 5.
Parameter Size: 1 Byte
Available Settings: 0, 1.
Default Setting: 1.
6. Configure power report
This parameter defines by how much power consumed must change to be reported to
the Z-Wave Controller or Z-Wave Gateway, in percents. If the rate of power
consumed change ratio is greater than this parameter, the plug will report the results,
voltage, current, power and energy, that plug measure to Z-Wave Controller or
Z-Wave Gateway.
Function: Power Reporting Setting
Parameter Number: 6.
Parameter Size: 1 Byte
Available Settings： 1 – 100 (%).
Default Setting: 30(%).
7. 7. Remember Relay ON/OFF status
This parameter defined the relay status if remember or not. If remembered, the plug
will restore the relay status last power off when the plug supply power next time.