User's Manual

Function: Remember Relay Status
Parameter Number: 7.
Parameter Size: 1 Byte
Available Settings： 0 - 255
0 – Don’t Remember, the relay will keep OFF when
Plug Supply Power.
Others – Remember the Relay Status.
Default Setting: 255.
8. Configure Plug Time switch Function
This parameter defines the timer function Enable/Disable. This parameter can be
configured with 0 or 1, where 0 means disable time switch function and 1 enable. The
time period will be defined in parameter 9#.If this parameter is Set to 1, and when
turn the plug relay on, the timer in plug start run with time period defined in
parameter #9 and the plug will turn the relay off.
Function: Time switch Configure
Parameter Number: 8.
Parameter Size: 1 Byte
Available Settings： 0, 1
0 – Time switch Disable.
1 – Time switch Enable.
Default Setting: 0
9. Configure Time switch Period
This parameter defines the time period that plug time switch off. This parameter can
be configured 1 ~ 65535(in minutes). If Parameter 9# is set to ‘1’, and relay is turn-on,
the relay will be turn-off after delay this parameter.
Function: Time switch Configure
Parameter Number: 9.
Parameter Size: 2 Byte
Available Settings: 1 ~ 65535 (minutes).
Default Setting: 150(min)
Command Classes
The Plug supports Command Classes as Below:
* COMMAND_CLASS_ZWAVEPLUS_INFO (V2)
* COMMAND_CLASS_MANUFACTURER_SPECIFIC (V2)
* COMMAND_CLASS_VERSION (V2)
* COMMAND_CLASS_ASSOCIATION (V2)
* COMMAND_CLASS_ASSOCIATION_GRP_INFO (V1)
* COMMAND_CLASS_DEVICE_RESET_LOCALLY (V1)
* COMMAND_CLASS_POWERLEVEL (V1)