Product Specs

Regulatory Module Integration Instructions
2.2 List of applicable FCC rules
This device complies with part2-Subpart J ,part 22-Subpart H,part 24-Subpart E,part
27 of the FCC Rules.
2.3 Summarize the specific operational use conditions
The input voltage to the module should be nominally 3.4-4.2V DC ，typical
value 3.8V DC and the ambient temperature of the module should not exceed
85℃.
If the antenna needs to be changed，the certification
should be re-applied.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body. If the device built
into a host as a portable usage， the additional RF exposure evaluation may be
required as specified by 2.1093.
2.7 Antennas
Comply with the antenna requirements of Section 15.203 and 15.204(c
), the
repuirements of antenna connector and spurious emission have been fulfilled,
the maximum gain of GSM850/LTE Band 5 is 2.41dBi,PCS1900/LTE Band 2 is 4dBi,
LTE Band 4/66 is 6 dBi.LTE Band7/38/41 is 9dBi,LTE Band40 is 0dBi.
2.8 Label and compliance information
The outside of final products that contains this module device
must
display a label referring to the enclosed module. This exterior label can
use wording such as: "Contains Transmitter Module FCC ID: PJ7-N58-LA
" ，or "Contains FCC ID: PJ7-N58-LA "，Any similar wording that expresses
the same meaning may be used.
2.9 Information on test modes and additional testing requirements
a)The modular transmitter has been fully tested by the module grantee on the
required number of channels， modulation types， and modes， it should not
be necessary for the host installer to re-test all the available transmitter modes
or settings. It is recommended that the host product manufacturer， installing
the modular transmitter， perform some investigative measurements to confirm
that the resulting composite system does not exceed the spurious emissions