SMART BRACELET user's manual Wear it properly The wristband is best worn after the ulnar styloid Adjust the size of the wrist according to the adjustment hole；Buckle belt buckle。 The sensor should be close to the skin to avoid moving。 Charge the bracelet For the first time, make sure that the battery is in normal power. If the power is not turned on normally, please connect the charger to charge the device, and the bracelet will automatically turn on.
System Requirements ： Android 5.0 or above; iOS9.0 or above;Support for Bluetooth 4.0. Device connection For the first time, you need to connect to the APP for calibration. After the connection is successful, the bracelet will automatically synchronize the time.
Bracelet reset device This function will clear all data of the bracelet (such as step counting) Under the power on state, touch the short press function key to light up the screen Whether the default clock page of the bracelet, press the short press function key to switch to view different pages, no operation default five-second screen Switch to the heart rate three-in-one interface to start the test, heart rate three-in-one interface 60s timeout automatically off screen (heart rate and blood pressu
The distance of motion is estimated based on the number of walking steps. Calorie Estimate the calories burned based on the number of walking steps Heart rate, blood pressure, blood oxygen three-in-one After entering the heart rate three-in-one test interface for a few seconds, the current heart rate, blood pressure, and blood oxygen test results are displayed.
When you fall asleep, the bracelet will automatically enter the sleep monitoring mode；Automatically detect your deep sleep/shallow sleep/wake up all night and calculate your sleep quality；Sleep data is only supported for APP viewing. Note:Wearing a bracelet to sleep will have sleep data and start to detect sleep at 10 o'clock in the evening. Sleeping 3/4 hours of sleep data will be synchronized to the APP while sleeping.
In the connected state, if the call alert function is enabled, when the call comes in, the wristband will vibrate and display the name or number of the caller.(You need to give APP read address book permission) SMS notification: In the connected state, if the SMS reminder function is enabled, the bracelet will vibrate when there is a text message. Other reminders: In the connected state, if this function is enabled, when there is a message such as WeChat, QQ, Facebook, etc.
When using the reminder function, you need to set it to allow "FitPro" to run in the background; it is recommended to add "FitPro" to the rights management and open all permissions. （Alarm setting） In the connected state, 8 alarms can be set. After setting, it will be synchronized to the bracelet; offline alarm is supported. After the synchronization is successful, even if the APP is not connected, the bracelet will be reminded according to the set time.
Set whether to enable the sedentary reminder function, you can set the reminder interval, if you sit for a long time in the set time, the bracelet will remind. (Raise your hand to brighten) Turn this function on. When the wristband is in the state of the screen, lift your wrist and turn the screen to yourself to light up the screen. (Do not disturb mode) Turn on the Do Not Disturb mode. You can set the Do not disturb time period.
synchronization Operating -10℃~50℃ sensor temperature System Low Power Acceleration Sensor iOS9.0 and above/Android 5.0 and above Requirements Precautions 1.Bathing and swimming should not be worn. 2.Please Connect the bracelet when synchronizing data. 3.Use the included charging cable to charge. 4.Do not expose the bracelet to high moisture, high temperature, or very low temperatures for long periods of time 5.The bracelet appears to crash and restart.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
