User Manual

--Keyboard Charging
In the middle of using the keyboard, if the keyboard red light flashes to remind you that the
battery capacity is not enough(less than 20%), at the time you are supposed to use USB cable
to charge the keyboard as follows:
（1）、One end of the USB charging cable is inserted into the computer USB port, the other
end is inserted into the keyboard USB port.
（2）、The Charge indicator is red during charging, it turns green color to remind the user that
the keyboard is fully charged.(The theoretical charging time needs 15 hours)
--Storage
（1）、When you're not using the keyboard, please don't forget to switch the keyboard power
switch to OFF to shut down the power and prolong the battery life.
（2）、If you want to store your keyboard for a long time, please don’t forget to charge the
keyboard to half capacity, you can use the detection button to check the battery power, when
the indicator light turns yellow color, the keyboard can be stored for the long time, which can
extend the lithium battery life.
--Trouble Shooting
（1）、The keyboard can not be connected with the Tablets
1、Please check the Pairing parts in this manual.
2、Please check if the pairing distance is within 10 meters.
3、Please check if the pairing device is changed, and do the re-pairing job.
4、Please check if your tablet are connected with other devices, and the reach the
maximum connection limit.
5、Please check the battery power is enough, otherwise recharge it.
（2）、Each time for switching off the keyboard and switching it on, or , the tablet power shut
down and reboot, the keyboard keeps dead：
①、When the problem occurs, please press any key on the keyboard and wait for 3
seconds, it will work normally, this is because both the keyboard or tablet needs to search for
the previously connected Bluetooth devices when it switches on after powered off , which will
take 2 to 3 seconds.
---FCC Federal Communications Commission Interference Statement
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested by a Class B digital device.
According to FCC Part 15 regulations, set this legislation is to give the installation process may
cause harm to the surrounding environment to provide the necessary protection. The radio
radiation will be produced in the course of using the equipment. If you do not comply with the
instructions for installation and use may affect signal reception of radio and television, you can
switch on and switch off this device to detect. Users can try the following steps to avoid such