Rev. A1 Arm Automatic Blood Pressure Monitor Instruction Manual BF5000B Thanks for purchasing the Arm Automatic Blood Pressure Monitor manufactured by Bpump. Please read the instruction manual before usage; Please dispose the Arm Automatic Blood Pressure Monitor and battery in accordance with local regulations.
Rev. A1 Table of Contents 1. Safety Information ................................................................................................... 3 1.1. Warning............................................................................................................................. 3 1.2. Contraindications ............................................................................................................. 4 1.3. Care and maintenance ............................................................
Rev. A1 1. Safety Information 1.1. Warning 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) Self diagnosis and treatment which use measured results may be dangerous. Follow the instructions of your physician or licensed healthcare provider. If cuff inflation doesn’t stop, remove the cuff or power off the unit, otherwise, it may result in a hazard condition. Only take measurement with the manufacturer supplied cuff, or else it will lead to inaccurate results.
Rev. A1 17) Do not measurement too frequent, or else it may result in bruising where the cuff is applied. 18) Do not apply the cuff over a wound or inflamed area. 19) Do not apply the cuff on the same limb where intravascular access or therapy or an arterio-venous (A-V) shunt is present, because of temporary interference to blood flow and could result in injury to the patient.
Rev. A1 should be done by authorized persons of manufacturer. Maintenance of the necessary technical document, including the schematics, key components list and etc., will provided by the manufacturer for maintenance personnel. 12) Care and maintenance of lithium battery: Please keep the unit away from the fire or heat source, do not put the waste of the unit or battery into fire. When the battery is full charged, please unplug the AC adapter as soon as possible.
Rev. A1 Model: BC×××× Cuff Label Fig 2 Note: Symbol for‖TYPE BF APPLIED PART‖ Display Fig 3 3. Power source The device is power by lithium battery, and can be charge using USB cable. Turn on the power switch when first used, the power switch is located at the back side of the device. When the battery is connected to the unit ,the LED display will lit -up for 3 second ,then the device power off.
Rev. A1 Do not plug in multiple plugs into same power outlet. Use the manufacturer USB cable only. If the battery is not charged when the low battery symbol is display ,the red battery symbol will continue display, and the device could not measure. The device will automatic shut off when the battery voltage is too low.
Rev. A1 6. Standby mode Under the first touch mode, without operation 2s to enter the standby mode, which can automatically detect the current settings and display the Bluetooth symbol, Horn symbol, blood pressure unit and user group.（Fig6） Press the 【 】button or without operation 20s during setting, memory and average value viewing will return to the standby mode. Fig6 7. System Setting 7.1 User conversion The blood pressure monitor is capable to hold 2 sets of memory data.
Rev. A1 a) Continues the broadcast setting, press the 【◄】or【►】 button will automatically turn on or off the broadcast system as shown on Fig 12 or Fig 13. b) Press the 【 3) 】button to confirm. Unit coversion (mmHg to kPa ). a) Press the 【◄】or【►】 button will automatically change the unit conversion either from mmHg or kPa as shown on Fig 14 or Fig 15. b) Press the 【 Fig7 】button to confirm and return to standby mode. Fig9 Fig8 Fig10 Fig14 Fig15 Fig13 Time is set to 24 hours.
Rev. A1 Try not to take your blood pressure if you are nervous or upset. If we are nervous, anxious, or agitated our blood pressure will rise. Rest for 5～10 minutes before taking a reading. Sit in a comfortable, relaxed position. Don't move around or talk while taking the blood pressure. Leave your legs in one position, breath freely and calmly. The blood pressure cuff should fit over about 3/4 of your upper arm. It should easily go around the arm and the Velcro should close tightly.
Rev. A1 Fig 17 8.4. Take Measurement After setting and wearing the cuff, the unit is ready for measurement: 1) For the most accurate result please relax, do not smoke, take deep breath, speak loudly or move around during the measurement. 2) Press the 【 3) 4) 5) 6) 7) 8) 9) 】 button under the first touch mode or standby mode to start the measurement. The "0" on the diastolic pressure position is flashing ,the monitor will send out a broadcast and the cuff is inflated.(Fig18).
Rev. A1 Fig18 Fig19 Fig20 Fig21 8.4.1 The blood pressure level indicator Please refer to Table 1 for the blood pressure level classification and definition. Table 1 WHO Blood pressure level Blood pressure range Severe hypertension (H3) Systolic≥180mmHg or/and Diastolic≥110mmHg Moderate hypertension (H2) Systolic≥160mmHg or/and Diastolic≥100mmHg Mild hypertension (H1) Systolic≥140mmHg or/and Diastolic≥90mmHg Prehypertension（Pre.
Rev. A1 (4) ―Your diastolic pressure is‖ + measured diastolic value + ―Millimeter of mercury/Kilopascal.‖; (5) ―Your pulse is‖ + measured pulse value + ―pulse per minute.‖; (6) ―According standard, your to World blood Health organization pressure level is optimal/normal/pre_hypertension/mild_hypertension/ moderate_hypertension/severe_hypertension.
Rev. A1 mode, press down the 【 】button exceed 6s to shut off the unit. 8.6. Memory 1) The Memory 1 and Memory 2 can hold up to 60 readings each. Enter the memory reading mode. Press the 【 2) 】 button to enter the memory reading mode. Read the memory values. Under the Memory reading mode, press 【►】button to view the latest value to the earliest value. Press the【◄】button to view the earliest value to the latest value.
Rev. A1 9. Data transmission The Bluetooth function of Blood pressure monitor turns on automatically simultaneously with device’s powering on, which can be searched by corresponding app used for physiological indexes management on Mobile phone for data transportation. 10. Power off （1）Under the clock mode, press the 【 （2）Press and hold the 【 】button for 3s. 】button for 6s except the clock mode.
Rev. A1 Abnormal How to correct (1) Check the power switch is turn on. (2) Connect the USB cable to charge the unit ,then try again. (1) Confirm the cuff is wrapped up correctly。 (2) If the user clothing restricts the normal flow, please remove the obstructing clothing and retake the Measured value are abnormally measurement high or low (3) Relax, place the elbow on the desk with palm facing up; cuff should align with heart level.
Rev. A1 electric shock Mode of operation Operating Environment Weight Continuous Applied part Temperature:+5℃～+40℃； Humidity:15%～93% Pressure: 70.0kPa～106.0kPa Altitude: ≤3000 m Storage and transport Environment 382g Size 120 mm×120mm×40mm Contents ·Cuff ·USB cable ·Storage case (Optional) ·Instruction Manual Body 10000 times Life time (Body) Cuff 10000 times Cuff Temperature:-25℃～+70℃； Humidity:10%～95% Pressure:50.0kPa～106.
Rev. A1 Disposal This product must not be disposed together with the domestic waste. All users are obliged to hand in all electrical or electronic devices, regardless of whether or not they contain toxic substances, at a municipal or commercial collection point so that they can be disposed of in an environmentally acceptable manner. Please remove the battery before disposing of the equipment.
Rev. A1 Stage 2 Hypertension 160-179 and/or 100-109 Hypertensive Crisis ≥180 and/or ≥110 These categories were defined by the American Heart Association. This chart applies to adults age 20 and older. 8.3. What is morning hypertension (morning surge)? Morning high blood pressure or morning surge is defined as the weekly average for morning blood pressure reading measured within 1 hour to 2 hours after awakening in the morning and exceeding 135/85mm Hg.
Rev. A1 Blood Pressure Measurement Chart Date Time SYS/DIA Pulse Remark Date Time SYS/DIA Pulse Guarantee Card Product Model Product SN Date of Purchase Distributor Customer Name Tel Address Details of the faults: Warranty Rule ·The unit of this product is guaranteed by PUMP for a period of 1year after the date of purchase. ·The guarantee does not cover any of the following: -- Risks of transport.
Rev. A1 SHENZHEN PUMP MEDICAL SYSTEM CO., LTD.
