User's Manual

Rev. A1
11
Fig 17
8.4. Take Measurement
After setting and wearing the cuff, the unit is ready for measurement:
1) For the most accurate result please relax, do not smoke, take deep breath, speak loudly
or move around during the measurement.
2) Press the 【 】 button under the first touch mode or standby mode to start the
measurement.
3) The "0" on the diastolic pressure position is flashing ,the monitor will send out a
broadcast and the cuff is inflated.(Fig18).
4) Pressure gradually increased, the current pressure is displayed on the diastolic pressure
position .When the device detects a pulse, the heart symbol will flash as shown on Fig
19. The cuff inflates, and your pulse and blood pressure measurement is taken.
5) If the cuff is too loose, the cuff self-test symbol will flash for 30 seconds, at this case,
please confirm the cuff is wrapped up correctly, and take the measurement again.
6) When completing the test, the cuff will automatically deflate and the test result will
display on the screen , the device will broadcast the result. WHO blood pressure level
(Optm, Norm, Pre.H, H1,H2,H3) display from left to right,(Fig 20) and then the level
not for the test disappear from right to left, only the blood press level for the
measurement display on the screen as show on Fig21. The blood pressure level
classification and definition as show in Table 1.
7) You may turn off the unit or compare with the previous results.
8) If a problem occurs during the test, ―Err‖ will display on the screen.
9) In the end of measurement, ― ‖ will display on the screen when irregular pulse is
detected.
10) Complete the measurement, press the 【 】button to take a measurement again; Press
down the 【 】button for 3s to return the standby mode.
11) Press down the 【 】button exceed 6s to shut off the unit, or automatic shut off without
operation for 3min.