User's Manual

Rev. A1
17
electric shock
Mode of
operation
Continuous
Applied part
Cuff
Operating
Environment
Temperature:+5℃～+40℃；
Humidity:15%～93%
Pressure: 70.0kPa～106.0kPa
Altitude: ≤3000 m
Storage and
transport
Environment
Temperature:-25℃～+70℃；
Humidity:10%～95%
Pressure:50.0kPa～106.0kPa
Weight
382g
Size
120 mm×120mm×40mm
Life time
(Body)
Body
10000 times
Contents
·Cuff
·USB cable
·Storage case (Optional)
·Instruction Manual
Cuff
10000 times
This unit is intended for home use and the specification may be changed without prior notice.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
The device complies with RF specifications when the device used at 0mm form your body.