User's Manual

Rev. A1
7
 Do not plug in multiple plugs into same power outlet.
 Use the manufacturer USB cable only.
 If the battery is not charged when the low battery symbol is display ,the red battery symbol
will continue display, and the device could not measure. The device will automatic shut off
when the battery voltage is too low.
 When the battery is charging, the battery symbol is green and flicker, when the green battery
symbol continues display ,the battery is full charged, unplug the AC adapter to avoid
damaging the battery.
 Unplug the AC adapter or wires if the device is damaged.
 Do not touch the AC adapter with wet hand.
 When operating the unit please do not tangle the power cords.
 The battery can not be replaced, when the battery reaches to its lifetime, the device scraped.
The scrapped device and battery should be handled in accordance with the provisions of the
state.
 In order to extend the lifetime of lithium battery, turn off the power switch if the unit will not
use for a long time.
 Reset the time and date after turn on the power switch.
4. Clock mode
With monitor power off, touch the 【 】 button into the clock mode, display the current
time (hour/minute).(Fig4)
 Under any mode, press and hold the 【 】button for 3 seconds will enter the clock mode.
 Under the clock mode, press and hold the 【 】button for 3 seconds or unattended 3 minutes
will shut off the monitor.
5. First touch mode
Under the clock mode, press the 【 】button to lit up the touch button area,(Fig5) press the
button into next step.
Fig4
Fig5