Specifications

9
3. Warning
FCC Warning：
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions.
(1) This device may not cause harmful interference;
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
INTEGRATION INSTRUCTIONS
1. This module has been tested and found to comply with the FCC Part15.247 for
Modular Approval.
2. This Modular Approval is limited to OEM installation for mobile and fixed applications
only. The antenna installation and operating configurations of this transmitter, including
any applicable source-based time- averaging duty factor, antenna gain and cable loss
must satisfy MPE categorical Exclusion Requirements of 2.1091. This modular should be
installed and operated with minimum distance 20 cm between the radiator& your body.
3. The U.FL connector antenna has been approved for the modular. The maximum
antenna gain is 3dBi. For situations where the host manufacturer is responsible for an
external connector, the integration instructions shall inform the installer that a unique
antenna connector must be used on the Part 15 authorized transmitters used in the host
product.
4. When the module is installed in the host device, the FCC ID label must be visible
through a window on the final device or it must be visible when an access panel, door or
cover is easily removed. If not, a second label must be placed on the outside of the final
device that contains the following text: ―Contains FCC ID: 2AF6B-RAK4200H.
5. The Shenzhen Rakwireless Technology Co., Ltd. uses various test mode programs for
test set up which operate separate from production firmware. Host integrators should
contact Shenzhen Rakwireless Technology Co., Ltd. for assistance with test modes
needed for module/host compliance test requirements.
6. The Shenzhen Rakwireless Technology Co., Ltd. modular transmitter is only FCC
authorized for the FCC Part15.247 listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host
not covered by the modular transmitter grant of certification. If the grantee markets their
product as being Part 15 Subpart B compliant (when it also contains
unintentional-radiator digital circuity), then the grantee shall provide a notice stating that
the final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.