User's Manual

FCC & IC Warning

This device complies with part 15 of the FCC Rules and Industry

Canada licence-exempt RSS standard (s). Operation is subject to

the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Any Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for

help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

Under Industry Canada regulations, this radio transmitter

may only operate using an antenna of a type and maximum

(or lesser) gain approved for the transmitter by Industry

Canada. To reduce potential radio interference to other

users, the antenna type and its gain should be so chosen that,

the equivalent isotropically radiated power (e.i.r.p.) is not

more than that necessary for successful communication.