User Manual

Keypad Functions

Installation

1. Plug the Micro receiver into a USB port of your computer.

2. Open the battery door and install battery.

3. Click the keypad key to get connected with the receiver.

Caution:

Before your keypad is connected with the receiver. You need to keep the keypad at a distance of less than 2

meter to the receiver to finish the initial connection.

Trouble Shooting

1. Check Micro receiver connection; try to inserting Micro Receiver to another USB port on your computer.

2. Connection between the keypad and the Micro Receiver. Re-insert the Micro Receiver. Take out the

battery and reinstall it.

Note:

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference

PAGE 1
Keypad Functions Installation 1. Plug the Micro receiver into a USB port of your computer. 2. Open the battery door and install battery. 3. Click the keypad key to get connected with the receiver. Caution: Before your keypad is connected with the receiver. You need to keep the keypad at a distance of less than 2 meter to the receiver to finish the initial connection. Trouble Shooting 1. Check Micro receiver connection; try to inserting Micro Receiver to another USB port on your computer. 2.
PAGE 2
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.