User Manual

1. Check to see if the batteries in the mouse are installed

correctly. Make sure the polarity of the batteries

corresponds with the polarity signs in the battery

compartment.

2. Replace the batteries to make sure the batteries are not

low on power.

Federal Communications Commission (FCC)

Notice

This device complies with Part 15 of the FCC rules. Operation

is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received,

including interference that may cause undesired

operation.

CAUTION!

The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modifications to this

equipment. Such modifications could void the user authority to

operate the equipment.

P/N: 266-80260-2008

Quick Start Guide

2.4GHz Wireless Super Mini Mouse

PAGE 1
. 2. Check to see if the batteries in the mouse are installed correctly. Make sure the polarity of the batteries corresponds with the polarity signs in the battery compartment. Replace the batteries to make sure the batteries are not low on power. Federal Communications Commission (FCC) Notice This device complies with Part 15 of the FCC rules.
PAGE 2
Installation 1. 2. Mouse Functions Plug the Nano receiver into a USB port of your computer. Push the Battery Cover Switch aside, open the battery door and install battery, then close the battery cover. Speed Control Receiver storage and ON/OFF the mouse 1. 2. 2 You can store or take out the Nano receiver from the Nano receiver storage by push/pull the Nano receiver. You can switch On or shut off the mouse by use the ON/OFF switch on the bottom of the mouse.
PAGE 3
FCC Statement to correct the interference by one or more of the following This equipment has been tested and found to comply with the measures: limits for a Class B digital device, pursuant to part 15 of the -Reorient or relocate the receiving antenna. FCC rules. These limits are designed to provide reasonable -Increase the separation between the equipment and receiver.