Instruction Manual
28
EN
No. Scenario Possible Cause Solution
4
Robot misses cleaning
spots to be cleaned,
or repeats cleaning the
area cleaned�
The cleaning cycle is interfered by small objects or
barriers on the oor.
Remove power cords and small objects from the oor
to ensure cleaning efciency. Robot will automatically
clean the area missed, please avoid moving Robot
manually or block the path during the cleaning cycle�
Robot is working on slippery polished oors.
Make sure the oor wax is dried before Robot starts
cleaning�
Robot is unable to reach certain areas blocked by
furniture or barriers�
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place�
5
Robot gets stuck while
working and stops�
Robot gets stuck while working and stops�
Robot will try various ways to free itself� If it is
unsuccessful, manually remove the obstacles and
restart�
Robot might be stuck under furniture with an
entrance of similar height�
Please set a physical barrier�
6
Robot is making too
much noise when
cleaning�
Robot is tangled or blocked with debris�
Clean Robot as described in section Maintenance and
restart� If the trouble persists, please contact Customer
Care�
7
Shaft Sleeve of the Main
Brush falls off�
Shaft Sleeve gets entangled by debris and falls off
during the cleaning�
Please clean up the debris and reinstall it�