User's Manual

2.
1.
3.
4.
5.
6.
7.
8.
9.
11.
10.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
Definition of Button Functions
Decoration Light Press to turn on/off
Camera/Light
The two versions are not applicably
combined for the helmet.
Buyer can choose either of the two,
which is factory setting.
Rear Warning Light
Press to turn on/off
On/Off
Press and hold the button for 2
seconds to turn on/on the helmet
Recording/WiFi
Press and hold the button for 1
second to start/stop
recording; press and hold for 3
seconds to turn on/off WiFi
Camera Mic
To pick up voice when the camera
gets into recording status
TF Card Slot
Open the silicone cover to put card
inside
Reset
Use a sharp object like needle to
restore the helmet
Buzzer
A speaker to reflect the current
status of camera recorder
BT Microphone
To pick up voice after BT gets
connects for intercom
BT Speaker (Left) For BT Broadcast
BT Speaker (Right) For BT Broadcast
Type-C
Interface for connecting to charge
the helmet
Replaceable Top
Cover
Different colors of removable cover
for replacement
Headlight Control
[Camera version]: Short press to turn
on/off the front decorative light
[Lighting version]: Short press 1 time
for low light,
short press 2 times to highlight,
short press 3 times to turn off
Left-turn Signal
Light Control
Press to turn on/off the light
Right-turn Signal
Light Control
Press to turn on/off the light
Short press to turn on/off parking lights
(in any light mode);When the parking
light is off, press and hold for 3 seconds
to enter the multi-color light mode,
and press and hold again for 3 seconds
to turn off
Rear Warning
Light Control
Intercom Control
When using Weila for chatting, press
19. to send audio messages
Charging Indicator
Red light means charging;
green light means fully charged
Type-C
Interface for connecting to charge the
RC watch
(must with adaptor DC 5V 1A)
Front and rear warning lights (Flashlight Version) are
controlled by remote controller buttons.Before the
operation for the first time of remote controller, please get
Bluetooth paired with helmet. Pairing method:Press power
button of the helmet;the helmet is turned on and it says
"Bluetooth is on, waiting for connection"; press Headlight
button on the remote controller and hold for 3seconds;
release the button when four LEDs light on; the four LEDs will
blink for 5 times then turn off, whichmeans pairing successful.
3