Quick Start Guide

Screw the WiFi antenna to connect to the antenna
socket on the WiFi NVR.
General Introduction
Antenna Socket
Ethernet Port
Micro SD Card Slot
Audio Out Port
VGA Port
Power Port
Power LED
HDMI Port
USB Ports
Hard Drive LED
Antenna
Microphone
Speaker(at back)
Daylight Sensor
Ture Detect™ Heat & Motion Sensor
Connection Diagram
Step 1 Turn the antenna base in a clockwise
motion to connect. Leave the antenna in a vertical
position for best reception.
Note: Before installing the antenna, you need to
fold the bracket of the camera as the picture shown
so that you can install the antenna easily.
Note: The Micro SD card can only record when motion detected. If you want to set the 24/7 video
recordings, please purchase and install the HDD to record. The way to install the HDD, please refer to
https://bit.ly/2HkDChC
To make sure nothing was damaged during shipping, we recommend that you connect everything
and try it before you do a permanent installation.
USB
HDMI
3English
2 English