Quick Start Guide

Step 4
Connect the supplied power
adapter’s power connection (1)
to the power input (2) on your
NVR first (to minimize sparking).
Connect the power adapter to a
power outlet to supply power.
Step 5
Connect the output on the power
cable to the power input on the
camera. Then connect the input
on the power cable to the power
adapter. The reset button is used
to restore factory default
settings.
After you connect the system according to the connection diagram, during the startup, you will see the
below splash screen after a few seconds.
If you want to initial setup the WiFi system on monitor, you need to connect the HDMI/VGA cable to
the HDMI/VGA port (1) then connect the other end to a spare HDMI/VGA input (2) on your TV.
Setup WiFi System on Monitor
You need to follow the Setup Wizard to set up your NVR by clicking "Right arrow"to continue and click
"Finish" to save your settings at the last step.
Step 2
Connect the supplied mouse (1)
to the bottom USB port (2). To
copy video recordings and to
perform a firmware upgrade,
connect a USB flash drive (not
included) to the top port.
DC12V
IN
USB
AUDIO
OUT
HDMIVGALAN
MicroSD
2
1
DC12V
IN
USB
AUDIO
OUT
HDMIVGALAN
MicroSD
1
HDMI
HDMI
2
DC12V
IN
USB
AUDIO
OUT
HDMIVGALAN
MicroSD
2
1
Step 3
Connect the supplied Ethernet
cable to the Ethernet port (1) on
your NVR then connect the
other end to a spare port (2) on
your router. Don’t proceed to the
next step until this is done.
DC12V
IN
USB
AUDIO
OUT
HDMIVGALAN
MicroSD
1
2
Reset Button
DC Power
Power Adapter
(12V)
3
2
1
4 English 5English