User's Manual

Audio Feature:(Optional)
Audio feature configuration is available for this device, including MIC, Speaker,
Headphone port, etc. Particularly, users can switch the voice broadcasting
mode between terminal and keyboard by Audio Switch. Under some systems,
the audio feature requires manual configuration.
Cursor drift correction
When used, the cursor automatically discovered drift, or do not follow the
hands-down direction cursor moves the cursor on the need for correction.
Methods of operation are:
(1) keyboard is turned on, the keyboard flat on the table.
(2) Press FN and then release the left mouse button, wait 3 seconds after the
calibration is completed
Auto sleep and wake up feature
The keyboard also have an auto sleep and wake up feature.Within three
minutes, if having no key pressed, the keyboard will automatically go into sleep
mode. In sleep mode, all lights extinguished state. Users can press any key of
the wireless keyboard surface to wake up the device
Switching off the keyboard after use
After using the keyboard, push the switch to the “OFF” position. This turns off
the keyboard. The USB receiver does not need to be pulled out from the PC.
You can use it directly next time.
How to operate (IR Remote)
(1)Press the SET of (IR Remote) more than 4 seconds,the (IR Remote)'s light
will be flash one time then long-time on;
(2)Aim the (IR Remote)'s infrared LED at your original remote control's infrared
LED in parallel alignment (PS: the relative distance not more than 7 cm), then
(3)press any button on (IR Remote),
the (IR Remote)'s light will flash two times then long-time on, it is in learning
status.
(4)Press any button on original remote control, (IR Remote) 's light will be flash
three times then long-time on,it is success in learning.
(5)Repeat the step 2-4, until finish learning all keys.
(6)Press the set key or 10 seconds without any operation, the device will retire
from the learning state.