User's Manual

S-8600 UHF RFID Reader User Manual
UHF RFID User Manual
12
Click on Tag Inventory (Real Time Mode). Select the checkbox for the port with a
connected antenna. Set the number of Repeat per command. This number is the times of
repeat inventory command. For example, per inventory command will execute
anti-collision algorithm one time when you set the value to 1. It will execute anti-collision
algorithm two times when you set the value to 2, and so on.
Next, click on Inventory, we can find that the EPC number is uploaded immediately and
real time update. If you do not click on Stop, the reader will keep inventorying. As shown
below:
Meaning of the data as shown below:
Total of inventory Tags
Total number of inventory tags since click on Inventory Tag.
Identification Speed
Speed of identification Tag, unit: piece / sec
Cumulative return data
Total return EPC data of tags (Including repeated reading of data)
Command execution
time
Time of each Inventory Command takes, unit: ms
Total running time
Total elapsed time since click on Inventory Tag, unit: ms.
Meaning of the data in Tag list as shown below:
ID
The serial number of data.
ＥＰＣ
EPC number of tag.
ＰＣ
Protocol Control word of tag.
Identification Times
Times of tag identified.
RSSI
The signal strength when tag was identified at the last time.
Carrier Frequency
Carrier Frequency of tag which is identified at the last time.
Next we will inventory tag under Buffer Mode.