User's Manual

S-8600 UHF RFID Reader User Manual

UHF RFID User Manual

2.6 Other Settings

2.6.1 Set DRM Status

DRM is Dense Reader Mode. When multiple readers work at the same time, the RF signal

transmission will interfere with each other, you can open the DRM mode to reduce the

interference between them.

Operation interface as below (Reader Setup->RF Setup):

Note: If DRM was opened, the sensitivity of the reader will reduce significantly. So users

could start this function according to the actual situation.

2.6.2 Operating Temperature Monitoring

Reader will generate heat under high intensity continuous working. Users can monitor the

internal temperature via the built-in temperature sensor to avoid reader overheating

(Operating temperature over 65℃). If it’s too hot, you could stop reading for a while.

Interface of the Temperature Monitor as below:

2.6.3 Set GPIO Level

General-purpose input/output (GPIO) is a generic pin on an integrated circuit whose

behavior (including whether it is an input or output pin) can be controlled (programmed)

by the user at run time. This reader provides two opto-isolated inputs (GPIO1 and GPIO2)

and two opto-isolated outputs (GPIO3 and GPIO4).

The image of GPIO port with connector as below: