User's Manual
S-8600 UHF RFID Reader User Manual
UHF RFID User Manual
8
If the reader is connected via TCP/IP, you need to operate these following steps,:
1. Ensure that an Ethernet Card has been installed in the PC.
2. Ensure that PC and reader in the same network segment.
Default settings of Reader as follows:
1. IP addresses: 192.168.0.178
2. Net mask: 255.255.255.0
3. Port No.: 4001
Detailed TCP / IP configuration, please refer to the document supplied:\ tcpip
configuration \ IPORT-1UM.PDF
Initial use, please configure it as illustrated below:
Click on Connect, if it connect successfully, the Operation history column displays:
Text communication with the reader:
Click on the button below the position shown in figure.