User Manual

ear button four times to enter the dual ear working mode, the left ear indicator lights flicker

alternately, the right ear indicator lights is off, and enter into the dual ear working mode.

Automatically connect back: Take out the headphones from the charging box, it will pare and

connect back to the mobile phone.

Charging Instruction:

Put the headphones in the charging box. The red LED of earphone will be on when they are

charging. After the battery power is full the LED will be off.

Be careful:

1. Don't fall, collide, scrub, twist, slap, grind or throw into the water.

2. Don't put headphones in extremely high temperatures.

3. Don't expose headphones to damp conditions.

Thank you for buying our products!

Best wish you like the new true wireless stereo headset.

If you have a good experience with our headphones, we would appreciate it if you could share

it with others.

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used

in portable exposure condition without restriction.