Operation Manual

Operation manual for temperature-measuring face recognition terminal
Chapter III Use of product
3.1 Basic use
The face recognition terminal can be used normally after connecting to
power supply and network. The specific method is as follows:
 Face - ID comparison
After accessing the ID reader, the ID icon will be displayed at the right
bottom of the main face recognition interface. The ID can be directly
placed in the card reading area, and the face - ID comparison threshold
can be modified in use.
 Whitelist comparison
To use whitelist comparison operating mode, personnel information of
whitelist shall be input into the face recognition terminal in advance.
The specific operations are as follows:
Method 1: Import the collected whitelist information into the face
recognition terminal by USB;
Method 2: Input the whitelist through the client software. Please refer to
the operation manual of the face recognition management system (client)
for details.
3.2 System parameter setting
The product can modify the system parameter configuration in two ways.
Method 1: Connect the mouse and click on the face dynamic icon at the
left bottom of the main interface of the system, then the password input
box pops up, and enter the system parameter setting page after typing in
the password (System default password: 888888)
Method 2: Connect the product to the client and modify the product
configuration parameters on the client. Please refer to the operation
manual of the face recognition management system (client) for details.
Page 7