Smart Watch User Manual
Please read the manual before use.
1. Safety Warning ◆ For maximum performance, the watch should be fully charged for at least 2 hours before use. ◆ The watch comes with an original security code 1122. Change the code to prevent unauthorized use. 2. Product details: Power button: Long press to turn On/Off; Short press to awake/dark screen/ back to main menu USB port: Charging/Data: Touch screen: each function (main menu) will be shown and displayed on capacitive touch screen. Sliding left or right will bring you to the next function page.
Android application usage (already installed) (Smart phone) Setting—Accessibility—Enter into Bluetooth notice (service), enabled this service. (Please choose “sure” when shown a warning notice) the application runs on the background automatically and sync function will be switched on as below: Click the Bluetooth notices and choose the Notification service, select your Personal or System application in Notify application. Telephone service is including SMS, incoming call and seek watch.
Please choose “sure” when there is phone book request. Notice: the Sync software can open in sync APP already installed and Accessibility, the mobile will show Bluetooth connected done after 2-5 min; the watch will inform you the time of Sync with phone. Messages coming in to the mobile will be readable from the watch. 3.3.2 From watch to phone BT dialer on Smart watch ---Search new device—found your smart watch (such as s9500)—connect. Then follow step 3.3.1 3.4 Basic functions: 3.4.
3.4.9 Pedometer It can be adopted as a tool to avoid insufficient or excessive exercise by measuring calories or calories consumption based on collected data, such as number of steps, distance, speed time, etc. to control exercise. If you want return to main menu but keep pedometer during the exercise. Please press the power button. 3.4.10 Sleep monitor Show your sleep quality base on your sleep times. 3.4.11 Sedentary remind You can set a time to remind you up to do some exercise. 3.4.
accessories. 4.3 Bluetooth will disconnect when out of range. 5. Common trouble shooting 5.1 Unable to switch on Press power button for 3 seconds Watch must be charged fully. 5.2 Shut down automatically Low power, please charge it. 5.3 Using time too short. Battery is not full; please make sure it is full power (full charge needs 2hours at least). During the use of SIM card, the power will be run off soon if the signal too poor. 5.4 Unable to charge.
FCC RF EXPOSURE INFORMATION: WARNING!! Read this information before using your phone In August 1986 the Federal Communications Commission (FCC) of the United States with its action in Report and Outer FCC 96-326 adopted an updated safety standard for human exposure to radio frequency (RF) electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies.
For more information about RF exposure, please visit the FCC website at www.fcc.gov Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it receives and also sends out radio frequency (RF) signals. In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones. Those guidelines are consistent with the safety standards previously set by both U.S.
Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder. RF Exposure Information: This product is compliance to FCC RF Exposure requirements and refers to FCC website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC ID: 2ATSTXG to gain further information include SAR Values. This device complies with part 15 of the FCC rules.
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver.