User's Manual

Z series IP camera user manual
15
Fig. 12
 Tick “Enable alarm” to active alarm function
 Setting alarm detection mode:
 Tick DIDO input(External sensor input)：if tick DIDO input, need to connect
external sensor at alarm input port, otherwise the function is inefficient;
 Tick moving detection：It will trigger the alarm when it detects any motion.
Sensitivity value 0 means disable moving detection;
Sensitivity value 1 means lowest sensitivity;
Sensitivity value 10 means highest sensitivity;
 During setting time, you can appoint alarm action:
 DIDO output(Linkage alarm system output)：Enable the function, to connect
alarm system to alarm out port, alarm time is 30 seconds;
 Video recording：Enable the function, to insert SD card, and ensure the SD
card works OK, you can set record time and video cache here;
 Image capture：You can set capture size, capture quality, image number and
image cache here.
 FTP transfer：enable the function, to set FTP server correctly, it will send
two pictures to FTP server each alarm;
 Send mail：Enable the function, to set E-mail correctly, it will send two
pictures to E-mail each alarm.