User's Manual
Table Of Contents
- 1.Introduction
- 2.Product Description
- 3.Indications for Use
- 4. Package Contents
- 5. Features and Benefits
- 6.Specifications
- 7.Operating Procedure
- 7.1 Product indication and key function
- 7.2 OLED screen description
- 7.3 Specific operation method
- 8.Changing the O-Ring
- 9.Attention
- 10.FCC Caution
- 11. Device Label
- 12.Label Symbols Defined
- 13.Prevention of Cross-Contamination
- 14.Troubleshooting
- 15.Manufacturer Warranty, Service and Support
- 16.Magnetic compatibility information
- Guidance and manufacturer´s declaration – electrom
- Guidance and manufacturer´s declaration – electrom
Min I(Smart) User Manual
6
6
Injection of state
Displays the current infusion status.There are two status
displays
1. Forward injection state
2. Suck back state
7
Injection pressure
status
Display current injection pressure
8
Injection pressure
value
Display the current injection pressure value
7.3 Specific operation method
Install Boost Pipe and needle:
Remove the protective cap from the front of the needle, taking care to protect
yourself.
First put (card type) special local anaesthetic and needle into the Boost Pipe, then
insert the Boost Pipe into the main body. Rotate to the right (clockwise) to install;
Rotate left (counterclockwise) to unload. As shown in the figure below:
1
starting up :
Long press Power/switch key for 3S or more, the screen lights up and enters
standby state.
2
Enter the parameter adjustment setting state:
After booting up, click Power/switch key to select the appropriate speed mode.
Long press the Injection mode setting key to select the forward direction of the
putter.