User's Manual

www.SolidRFCanada.com 4
Installation
3
Note3: Don’t cover the booster body with
anything, in case the power dissipation make the
booster too high temperature. The booster will shut
down when the temperature is too high itself.
Note2: Use only the power supply provided by
SolidRF, any other products non-approved by
SolidRF or self-made power cable may damage the
booster.
Note4: Troubleshooting
• Properly: when the “power on LED” and “signal level
LED” are lighted, the “Alert LED” is off (no phone
calling and pads communicating) or flashing
(someone on the phone call). The booster is in good
condition;
• Wrong condition: any time the “Alert LED” in stable
red color or green color, please check the installation
by following this manual again.
Technical specification
Frequency
(MHz)
Cellular (band 5) PCS (band 2) Band 12/ Band 17
Uplink 824-849 1850-1910 698-716
Downlink 869-894 1930-1990 728-746
Gain Uplink 60±2 65±2 60±2
Downlink 61±2 68±2 61±2
Output power 23±2dBm(Uplink)/0±2dBm(Downlink)
Noise figure <3dB
In-band Flatness <5dB
Weight 0.7Kg
EIRP 1W
Gain adjustment 20dB
Impedance 50 ohm
Operating
temperature
-20°~50°
Current ≦1.5A(12V DC)
Dimension(mm) 155*125*25
Technical Support: [e-mail]
Note1: about the outside antenna and
outside booster unit
The outside antenna and outside booster
unit are integrated design, both them are
waterproofed design. No matter rain or
frog, they will work properly. But extreme
temperature maybe causes problem to the
booster unit, it will work perfectly from -
20℃ to +55 ℃ temperature range. Too high
or low temperature beyond that range will
cause self-protection, the booster will
lower down output power to avoid damage.
Outside booster unit
Outside antenna