User's Manual

www.SolidRFCanada.com 5
Warnings and Recommendations
Warning: This consumer booster is for Consumer use only.
Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by FCC
regulations. Please contact FCC for details: 1-888-CALL-FCC.
Warning: Outside antenna orientation must be back side of inside antenna is to prevent the indoor
antenna receiving the signal emitted by outside antenna. Otherwise it will cause self-oscillation of
booster.
Warning: RF safety, any antenna used with this device must be located at 20 cm (8 inches) away
from persons or by bystanders.
Warning: It will damage the mobile device and the booster if connect them with a cable directly.
Warning: Use the power supply provided by SolidRF only. Other power supplies may cause damage
of the booster.
Warning: Antenna installation is restricted to 10 meters or less height above ground, even if the
antenna is installed inside when used with a mobile device that operates in the 1710-1755 MHz
band. Violation of this requirement may subject the owner of the booster to potential FCC
enforcement actions.
Warning: Never point the front of a directional antenna toward the inside antenna. Verify that
both the outside antenna and the inside antenna are connected to the booster before powering up
the booster.
Description of network protection features:
This booster including safeguards to protect the cellular network from interference. Each Signal
Booster is individually tested and factory set to ensure FCC compliance.
1. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware.
2. The Signal Booster will amplify, but ONLY incoming and outgoing signals in order to increase
coverage of authorized frequency bands.
3. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected.
4. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation,
the Signal Booster will automatically turn the power off on that band.
5. For a detected oscillation the Signal Booster will automatically resume normal operation after a
minimum of 1 minute. After 5 times consecutive such automatic restarts, if the detected
oscillation still remains, any problematic bands are permanently shut off until the Signal Booster
has been manually restarted by reconnecting power supply to the Signal Booster.
6. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
This is a CONSUMER device
BEFURE USE ,you MUST REGISTER THIS DEVICE with your wireless provider and have
your provider’s consent .Most wireless provider consent to the use of signal boosters
.Some provider may not consent to the use of this device on their network .If you are
unsure, contact your provider.
You MUST operate this device with approved antenna and cables as specified by the
manufacturer .Antennas MUST be installed at least 20cm (8inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed
wireless service provider.
WARNING.E911 location information may not be provided or may be inaccurate for calls
served by using this device.
This device may be operated ONLY in a fixed location for in-building use.