User Manual
a cell tower but still experience failure data connection. This often occurs in buildings
in which stucco, concrete or metal walls may block the signal.
Easily solve these problems by installing a SolidRF booster.
Overview of installation
Overview of installationOverview of installation
Overview of installation
1.
Select installation location away from direct sunlight, heat, water and proper
ventilation.
2.
Run the Outside Antenna cable to the Signal Booster and attach it to the connector
labeled “Outside” on the Signal Booster. Connect cellular modem and the “inside”
connector of the signal booster by using “Inside Antenna”.
3.
Before powering up the Signal Booster, verify that both the Outside and the Inside
connectors are connected properly and check that all connections are tight.
Note: Be
careful when plugging the connectors in so as not to bend the center pins on the
connectors
.
4.
The Signal Booster has been packaged with the gain control knobs adjusted to the
highest gain position.