User Manual

1 ≥ -85dBm
2 ≥ -80dBm
3 ≥ -75dBm
4 ≥ -70dBm
5 ≥ -65dBm
6 ≥ -60dBm
7/8 ≥ -55dBm
E Over heat / the antennas are
NOT installed properly.
F Self-Protection
Table 1
MODE button: press it to choose LED display modes:
1. Turn off all display (except power light).
2. Display circularly the output signal strength of 800MHz, 1900MHz.
3. Display the output signal strength on the band selected by PRESS
Band button.
Band button: when LED display mode has been set as MODE 3, press it to choose a
band and display its output signal strength on LED.
Blue knobs: Adjust the booster’s gain from minimum 0dB to maximum15dB, Adjustment
to the OFF position close the band uplink and downlink link, LED display red.
Band lights: it shows the status of indicated band. Flicker means the booster fail on the
band.
Power light: It indicated whether the power is on.