Window Cleaning Robot Window Cleaning Robot User Manual
1
2
About Window Cleaning Robot GlassBot is a cleaning robot that works on multiple surfaces of glasses, tiles, smooth walls and tables. It works with a built-in vacuum motor that helps it suck air and stand on the glass surface. An embedded UPS (Un-interrupted Power System) prevents the robot falling from the window even when no electrical power.
Know Your GlassBot Top View Buzzer Hooking Hole Air Vent ④ ⑥ ① ⑤ ② ⑦ ③ 4 ⑧
Know Your GlassBot Remote Control The device can be remote controlled from the front and backside. A B STAR T STO P Automatically move up then down Manually move up Automatically move left then down Manually move down Automatically right then down Manually move right move Stop Cleaning Manually move left Start Stop Cleaning Auto Up then Down Auto Left then Down Start Cleaning Auto Right then Down Please remove the insulation spacer in the bottom of back of remote controller before useing.
Before Using ► The robot shall always connect power cable for normal using. ► How to put the robot onto glass to start using? (1) Turn on power-switch, and then make sure the fan is running. (2) Put device onto glass and keep 10cm away from the window frame. (3) Check if device can stick to the glass before releasing it. ► How to take device down from glass? (1) While device is running, please hold safety rope with one hand and take device down from glass with the other hand.
Power Adapter/DC Extension Cable Power adapter DC plug L-shape connector Plug into DC power jack DC extension cable Using/Changing the Cleaning Cloth 1. Put clean-and-dry cleaning cloth onto cleaning ring. 2. Put the cleaning ring onto clean wheel and ensure the 6 slots on the ring are well fixed with the cleaner wheel to avoid air leakage. Frequently Asked Questions (FAQ) Q1: If Robot can’t startup and alert at the beginning of self-test. Ans: It means that the friction factor is not properly used.
Q2: Robot slips and cannot detect the upper frame of window in “Auto Up then Down” mode Ans: Press key and switch to or mode to continue cleaning. Q3: Robot cannot finish whole window and stop at middle area. Ans: Press or mode to continue cleaning. Q4: Robot slips and cannot get higher to the window frame. Ans: (1) Friction factor is too low that might be caused by glass stickers, window film on the glass. (2) Cleaning cloth might be too wet.
9
10
Control it with your smart phone Users can control the cleaner through bluetooth matching to your smart phone, which is simple and convenient. ※ IOS System: Requires iOS 7.0 or later. Compatible with iPhone, iPad, and iPod touch. ※ Android System: Requires Android 4.3 or later, bluetooth 4.0 or later. How to control it through APP ? 1. Connect the robot to power supply and press “Start” to turn it on The robot has to be turned on so the program can be found and matched to your smartphone. 2.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
