Operation Manual

TeamGee Electric Skateboard
25
Battery:
Forbid plugging conductive objective into the charging interface; otherwise, the internal electronic devices in the
skateboard might be short circuited and damaged, and it might even be dangerous. Please use the electric skateboard at
10-30
℃
as much as possible; otherwise, it will accelerate the aging of battery at high or low temperature, accelerate the
attenuation of battery capacity, shorten the battery life, and reduce the driving millage.
In case of failure with the battery, dispose of it by the authorized agent of electric skateboard, and forbid
dismantling and adapting it without permission.
Charging:
The lithium battery has no memory function, and it can be charged whenever needed. To extend the battery life
maximally, please fully charge the battery every time after riding. If you charge the skateboard battery only when it has
been used up, the lithium battery will be over-discharged, and the battery life will be attenuation sharply. Forbid charging
the over-discharged lithium battery (it could not be charged)! There is potential safety hazard with the over-discharged
battery, so please scrap the battery.
If you don’t ride the electric skateboard for a long time, put it in a cool and dry indoor place, fully charge the
battery, maintain at least 80% battery level, and charge it at least once every two months.
Cleaning:
Ensure the skateboard is powered off, unplug the charging cable, snap the dust cap off the charging interface, then wipe
the shell or surface of the electric skateboard with a wet cloth, and don’t allow water to flow into the charging interface or
the shell of the electric part, to avoid damaging the electric skateboard.
Maintenance:
Regularly inspect the bridge nuts and truck bolts at installation position of front and rear bridge component, and tighten
them timely if they are loose.
If there is “chatter” sound during the riding, add a few drops of lubricating oil at the position of bridge PU and top PU in
time to lighten the wear.
Please regularly check whether the left and right PU wheels of skateboard and motor PU jacket are worn seriously,
whether the bearing is worn and makes abnormal sound and the skateboard slides smoothly. For the seriously worn PU
wheel, please have it replaced by the authorized agent or dealer’s customer service staff.
Regular use of high temperature lubricating oil in motor PU groove can prolong the service life of motor PU wheel and