User's Manual Part 1

III Features & Configurations
29
 To set up Internet, see WAN Setup.
 To set up speed and duplex mode for the WAN port, see WAN Speed Setup.
 To configure DNS server, see DNS Setup.
 To clone MAC address, see MAC Clone.
 To configure DHCP server, see DHCP Server.
 To assign static IP addresses and view LAN device information, see DHCP Client List.
2.1 LAN Settings
Here you can configure the LAN IP Address and Subnet Mask. This IP address is to be used to
access the device’s settings through a web browser. Be sure to make a note of any changes you
apply to this page.
Tip-------------------------------------------------------------------------------------------------------------------------------------------
1.Default IP address and subnet mask are respectively 192.168.2.1 and 255.255.255.0.
2. Be sure to make a note of any changes you apply to this page. If you change the LAN IP
address of the router, you have to open a new connection to the new IP address and log in again.
Also, you have to set the default gateway addresses of all LAN PCs to this new IP address.
3. The router's LAN IP address and WAN IP address cannot be on the same IP segment. If not,
the router will not be able to access Internet.
Configuration Procedures:
① Change the IP address to the one you wish to use, for example, 192.168.10.1.
② Click Save to save your settings.