5/8 Ports Gigabit Ethernet Switch User’s Guide VER:1.
TABLE OF CONTENTS 1 INTRODUCTION 1.1 ·· Unpacking········································ 2 1.2 ·· Front Panel······································· 2 1.3 ·· Rear Panel ······································ 2 1.4 ·· Led Indicators ·································· 2 1.5 ·· Features············································ 3 2 PERFORMANCE FEATURES 2.1 ·· Performance Features······················· 5 3 INSTALLATION 3.1 ·· SWITCH to PC ································ 6 3.
1 INTRODUCTION 1.1 Unpacking Open the box and carefully unpacks its contents. The box should contain the following items: • One Gigabit Switch • One external power adapter • User’s Guide. If any item is found missing or damaged, please contact your dealer for replacement. 1.2 Front Panels For detail of the LED indicators in the front panel of the switch, refer to the LED Indicator section for detailed information about each of the 5/8 ports switch’s LED indicators. 1.
LED Indicator Color Status Green Light — Extinguish Green Light Green Blinking Green Light — Extinguish POWER LINK/ ACT 1000M Description This indicates the Switch is turned on If this indicator is not light, check the AC power connector to ensure proper insertion of the power cord and the power switch is turned on.
bandwidth-intensive files faster. The 5/8 ports switch combines large dynamic memory allocation with store-and forward switching to ensure that the buffer is effectively allocated for each port, while controlling the data flow between the transmit and receive nodes to guarantee against all possible packet loss. It can detect 10M/100M/1000M and full duplex/half duplex mode, plug-and-play and no configuration is required. 2 PERFORMANCE FEATURES 1. Complies with IEEE802.3, IEEE802.3u, IEEE802.
2.1 Performance Features General Criterion Protocol Topological structure Network Twistedpair Port amount features IEEE802.3 10BASE-T Ethernet IEEE802.3u 100BASE-TX/FX Fast Ethernet IEEE802.3ab Gigabit Ethernet CSMA/CD Star-network 10BASE-T: Cat. 3 or above UTP/STP 100Base-TX：Cat. 5 UTP/STP 1000Base-T：Cat.
3.1 SWITCH to PC A PC can be connected to the switch via a Cat. 5 or. 5e UTP/STP cable. The PC can be connected to any of the5/8 ports. 3.2 SWITCH TO SWITCH Like connection with the hub, the connection is accomplished from any port of the switch to the 5/8 ports Gigabit switch . 4 APPENDIX • The standard RJ-45 receptacle/connector RJ-45 Connector pin assignment Pin No.
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. NOTE: The manufacturer is not responsible for and radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
