Installation Instructions

1.Get the air vent clip from the package
2. After get the air vent clip from the package, align the
position of the mounting nut and rotate the nut to clamp
the air vent clip
Three-axis linkage
X11
3. The product will automatically adjust the extendable foot according
to the size of the mobile phone, and automatically calibrate the
position of the wireless charging coil.
This smart car wireless charging stand is an intelligent product with a
Simple design,Safe, support Qi standard, Compatible with all wireless charging
mobile phones that support qi standard protocol . No need to plug in the data
cable when charging the phone, which provides you with a convenient and safe
charging environment.
LED lights
LED lights
Wireless charging area
4.After installed wireless charger with air vent,place it on
related position in the car,connecting USB cable
At this time,
the LED light status is colorful cycle breathing (standby)
5.Two clips will automatically open an grip your moblie phone
when you place moblie phone close to wireless charger holder
with 100MM,
At this time, the LED light status is blue (charging).
6.When wireless charger is in abnormal working state,(detects other
objiects or dysfunctiTohne) status of the LED light is flashing red.
15W
Input：5V/2A；9V/1.67A
Ouput power：15W/10W /7.5W /5W
Charging distance：≤8mm
Charging efficency：≥76％
Operation Frequency：110kHz-205KHz
3-in-1 wireless charging station
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. During the operation of device a
distance of 15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
FCC StatementFCC Statement