Instruction Manual

Shenzhen Tengtek
6
3. Clean
(1) Before cleaning the unit, remove the power plug from the AC power socket; otherwise,
electric shock may occur. Please wipe the housing with a soft dry cloth. Do not spray
volatile compounds on the housing
(2) Please use neutral detergent dissolved in water to wipe and avoid touching the LCD
screen if the case is dirty
(3) Do not use thinner, gasoline, alcohol and other organic solvents to wipe the machine;
When wiping the LCD screen, be sure to use a special LIQUID crystal cleaning cloth, or a
very soft cotton flannelette, spray a proper amount of non-ionic water, so that the cleaning
cloth slightly damp, and then gently wipe; LCD screen is very "delicate", must be wiped
gently, in case of broken scree.
4. Move the machine
The machine must be moved by two or more people. When moving, do not shake or
shake the whole machine too much. The whole machine may fall and damage or cause
personal injury.
Note
This device complies with Part 1 5 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device is verified Io comply with Part l5of the FCC Rules for use with cable
television service.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the