Quick Start Guide

Working Temperature: -20°C ~ +55°C
Storage Temperature: -40°C ~ +70°C
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Hereby, [Shenzhen UniStrong Science & Technology Co.,Ltd.] declares that the radio equipment ype
[UT30] is in compliance with Directive 2014 / 53 /EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://en.unistrong.com/declaration.html
This device complies with Part 22 & 24 and Part 27 of the FCC Rules.
SAR INFORMATION
Charging mode need to operate indoors, please pay
attention to the environment temperature should be
0℃ ~ +45℃
NOTICE:
The SAR limit of Europe is 2.0 W/kg. Device types UT32 has also been tested against this SAR
limit. The highest SAR value reported under this standard during product certification for use on the
body is 1.08W/kg This device was tested for typical body - worn operations with the back of the
handset kept 0 cm from the body. To maintain compliance with RF exposure requirements, use
accessories that maintain a 0 cm separation distance between the user's body and the back of the
handset. The use of belt clips, holsters and similar accessories should not contain metallic
components in its assembly. The use of accessories that do not satisfy these requirements
may not comply with RF exposure requirements, and should be avoided.
The SAR limit of FCC and ISED is 1.6 W/kg averaged over one gram of tissue. Device types UT32
( FCC ID:2AOPD-UT32 and IC: 1
1546A-UT32 ) has also been tested against this SAR limit. The
highest SAR value reported under this standard during product certification for use on the body is
1.167
W/kg. This device was tested for typical body -worn operations with the back of the handset kept
0 cm from the body. To maintain compliance with FCC and ISED RF exposure requirements, use
accessories that maintain a 0 cm separation distance between the user's body and the back of the
handset. The use of belt clips, holsters and similar accessories should not contain metallic compo-
nents in its assembly. The use of accessories that do not satisfy these requirements may not
comply with FCC and ISED RF exposure requirements, and should be avoided.