User's Manual

Bodypack Receiver

17. Power and Volume Control: Combo power ON/OFF switch and earphones volume adjust

18. Earphone Out: 1/8” (3.5mm) jack for connecting monitoring earphones

19. Antenna: permanently attached

20. RF Signal LED Indicator: Lights RED when receiving transmitter’s signal

21. LCD Display: Displays selected frequency and battery life status (0 Bar=Empty)

22. Infrared Receptor/Sender LED: Synchronizes operating frequency between transmitter and receiver as

selected by either

23. Stereo/Mono Switch: Selects either stereo or mono output to earphones

24. Limiter Switch: Select to limit the audio output level to earphones

25. Battery Compartment: Holds 2 x AA Betteries

26. Battery Compartment Door: Covers batteries and selection buttons

27. LOCK Button: Locks the receiver controls to prevent accidental adjustment

28. SYNC Button: Press to download receiver’s Autoscan selected frequency to receiver via infrared link for

frequency synchronization

29. AUTOSCAN: Press to automatically ﬁnd open channel

30. MUTE Button: For muting the audio output to the headphone

31 . Belt Clip: Rotates 180

for attaching to belt with receiver’s top panel in either up or down position

For syncing Receiver-Selected Frequency to Transmitter: Press the receiver Auto-Scan Button (29) to locate

an open frequency/channel. Point the Receiver Infrared IR receptor/Sensor(22) at the transmitter Infrared

Transmission Window (5) and press the SYNC Button (28) on the receiver until the transmitter’s LCD

Screen (4) displays the same frequency as the receiver’s LCD Screen (21).

8. The receiver’s LCD display can be locked with the LOCK Button (27) to prevent accidental

adjustment, or to unlock it to make an adjustment later. The “LOCK” icon will be displayed

on the LCD screen in lock mode only. Push the Lock button to unlock.

9. The headphone audio can muted temporarily by pressing the MUTE Button (30). Press

again to un-mute. The “MUTE” icon will be displayed on the LCD screen in mute mode

only.

10. Wearing the Bodypack Receiver.

The Belt Clip (31) rotates 180˚ for attaching to belt with receiver’s top panel in either up or

down position as pictured below.