Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker TLT-1C GPS/GSM Car Tracker Instruction Manual V3.0 Shenzhen V-sun Electronics Co. Ltd.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Contents Chapter One ..................................................................................................................................... 5 Preface Preface..................................................................................................................................... .....................................................................................................................................5 I.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 11. Instruction for incoming call restriction switch................................................................................. 22 12. Phone positioning function................................................................................................................ 22 13. Emergency alarm (SOS).................................................................................................................... 22 14. Power off Alarm..
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 8. Emergency upload............................................................................................................................... 35 9. Low voltage upload............................................................................................................................. 35 10. Historical data upload function..........................................................................................................35 11.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Chapter One Preface I. Overview TLT-1C is a perfect combination of GSM and GPS technologies. The advanced technologies of the product in GSM and GPS fields are verified by its accurate dimension and simple appearance. It represents a typical design integrating the communication product and GPS positioning. We provide professional safety-guarding and car-positioning products and solutions.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Chapter Two Device Description I. Brief Introduction TLT-1C GPS/GSM is a car remote positioning and tracking device produced based on GPS technology and GSM/GPRS technology.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 7/40 GPS chip GPS chip set with high sensitivity GPS sensitivity -160dBm GPS frequency L1,1575.42MHz Code C/A Code Channel 50-channel, omnibearing tracking Position accuracy <2.5m,CEP Speed accuracy 0.1m/s Time accuracy 1us and synchronous with GPS time Coordinates WGS-84 Reacquisition 0.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 2. Product appearance 1.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Figure 2 Product Back View 3. LED status description 3.1 Green LED ---- GPS status indicator Status Description Off GPS unavailable Quick flash GPS available 3.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Status Description Quick flash No SIM card or GSM network Flash once every 8s GSM works normally 3.3 Red LED ---- charge indicator Status Description Normal light Under charging Weak light Charging completed 4. Product installation 4.1 SIM card installation a. Select SIM card ● You can use SIM card provided by local mobile operators operators.. ● It supports SMS/GPRS function and has enough balance. ” in the round hole on SIM b.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 4.2 Installation of external power wire General view of external power wire.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Figure 4 Connection method of relay 5. Product accessories 1. TLT-1C GPS/GSM Car Tracker 2. Power wire 3. GPS/GSM antenna 4. Earphone 5. Battery 6.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Chapter Three Initial Use and Model Description After reading brief introduction to the product, you must know how to install the product. Then it comes to product’s use. Firstly, as the user of such product, you need to pre-store telephone number before performing instruction operation on the device.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker SET MODE OK, CURRENT MODE: SMS P2P will return confirmation message “SET P2P”. GPRS online working mode: Instruction format: 710+user password (4 digits) For example: 7100000 Description: When TLT-1C receives the instruction, it will automatically switch to GPRS mode. After success, it will return confirmation message “SET MODE OK, CURRENT MODE: GPRS”.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Chapter Four Application and Operation in SMS Mode Most instructions are operable under both SMS mode and GPRS mode unless otherwise specified. 1. Instruction to change user password Instruction format: 777+new password (4 digits) + old password (4 digits) For example: 77712340000 Description: The terminal receives the instruction and return confirmation message after success. The message is “SET USER PASSWORD OK”. 2.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Time: 16:39:45 BS: 25ee0dff Fix: A ID: 353686009002030 STATE: SMS Note: 1. In case of cold start and GPS is not positioned, invalid message will be returned: GPS UNAVAILABLE, PLEASE TRY AGAIN LATER. 2. Inquire for position corresponding to latitude and longitude on Google map. Search for obtained latitude and longitude on http://maps.google.com to view detailed position corresponding to latitude and longitude.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Figure 4 You can also input position data into local map software on PDA or navigation device to view the position (as shown in the following graph) Figure 5 3.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker For example: 6670000 Instruction format 2: 667+user password+MAP For example: 6670000MAP Instruction format 3: 667+user password+MAP,WWW,HHH,ZZ For example: 6670000MAP,640,480,15 Description: 1. When the device receives instruction 1, it will immediately read GPS information and return Chinese address information to the sending number.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 5. Instruction to return map link for single positioning Instruction format: 669+user password For example: 6690000 Description: When the device receives the instruction, it will read GPS information immediately and return Google map link of local position to the number. User can use PDA or smart phone to view local position on Google map. Website example: http://maps.google.com/maps?f=q&hl=en&q=22.554765,114.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker information: SET BASESTATION OK. Note: 1. X is base station number with value range of [0, 6]. 2. If X is 0, position information contains no base station information. 3. Default number of base station is 1. 8. Read base station information Instruction format: 111+user password (4 digits) For example: 1111234 Description: After success to receive the instruction, the device will return the following message to the sender.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Description: When receiving the instruction, the device will set status of earphone switch in accordance with X value. X=1, earphone is switched off and the device is in monitoring mode. After setup is successful, the device will send confirmation information to the sender: SET PROFILE OK, CURRENT PROFILE: SILENT. After earphone is turned off, if prestored phone calls in, the terminal will not give prompt sound.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker returned from “request for single positioning” to the three prestored phone numbers. Information status is STATE: SOS. At the same time, the first prestored phone number will be called. If it fails (the phone is turned off or cannot be connected), the second and the third phone number will be called in sequence. Note: If calling status is off, message will be sent to prestored user instead of calling him. 14.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 2. Recovery of fuel cutoff/power failure 15. 15.2. (resume the oil and power) 15.2.1 Fuel cutoff/power failure recovery instruction: 902+user password 15.2.2 Fuel cutoff/power failure recovery confirmation instruction: 903+user password Description: After success to receive the instruction 902, TLT-1C will send confirmation information “Confirm Power ON?” and wait for instruction 903.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker For example: 0030000E11406.0024N2233.4230R0.1 When receiving the instruction, TLT-1C will return confirmation message to the sender: SET GEO-FENCE OK and turn on Geo-fence function. Description: E: east longitude; W: west longitude; N: north latitude; S: south latitude. south latitude. Here E and N are used to explain as an example. Please select corresponding coordinate formats in accordance with actual geographic position.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker After receiving the instruction, TLT-1C will return confirmation message: GEO-FENCE ON. 16.1.2 Turn off round Geo-fence instru instruction: Turn off geo-fence: 210 + user password After receiving the instruction, TLT-1C will return confirmation message: GEO-FENCE OFF. Note: 1. Fence radius shall not exceed its defined domain. When decimal digit is 0, please add 0. For example, when R is 1, please enter 1.0. 2.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker For example: 3110000G5 Description: The instruction is used to turn on all square Geo-fence and turn on single square geo-fence. GX stands for Geo-fence X, whose value range is【1,16】. After receiving the instruction, TLT-1C returns confirmation message: SET ALL SQUARE GEO FENCE: ON. When turning on single square geo-fence, it returns confirmation message: SET SQUARE GEO FENCE GX: ON. 16.2.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker returned from “request for single positioning" to the three prestored numbers immediately. Information status is STATE: SAFE SPEED. It will also call the first prestored number immediately. If it fails (the phone is turned off or cannot be connected), the second and the third phone number will be called in sequence. 18. Mileage statistics function 18.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 19.1 Turn on tow truck alert: 181 + user password For example: 1810000 .2 Turn off tow truck alert: 180 + user password 19 19.2 For example: 1800000 Description: After receiving the instruction, TLT-1C will return confirmation message: TOWED ALERT ON. Now, tow truck alert function has been activated.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 22.1 Instruction to set movement warning area: 008 + user password + Rzzz.z For example: 0080000R100.0 22.2 Instruction to turn off movement warning: 009 + user password For example: 0090000 After receiving instruction 008, TLT-1C will return confirmation message: SET MOVE RADIUS OK OK. After receiving instruction 009, TLT-1C will return confirmation message: MOVE DEFENCE: OFF OFF. Description: 1. zzz.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker For example: 1000000 Description: After receiving the instruction, TLT-1C will return confirmation message: VIBRATION SENSOR ON OK. Note: 1. If built-in vibration sensor detects device vibration, it will turn on GPS. If it does not detect vibration within 5 minutes, GPS will be turned off automatically. 2. If the car travels on the highway or the flat road for a long time, GPS may remain in sleep status rather than awake for a long time.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Chapter Five Application and Operation in GPRS Mode Send “710 + user password” to switch to GPRS mode. In the mode, TLT-1C can also prestore three phone numbers (No.1, No.2 and No.3), a set of TCP/IP server IP address and port number, 4-digit GPRS password and an APN number at GPRS access point. Instructions in SMS mode can also be used in GPRS mode. 1.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Instruction format: #804#user password # fixed IP address/ domain name #port## For example: #804#0000#210.83.225.181#6998##, Or #804#0000#www.gps068.com#6998## Description: After receiving the instruction, TLT-1C will return confirmation message: SET SERVER IP AND PORT OK. 5. Set timing data upload Timing data upload has the following two modes: traveling car tracking mode and turn-off mode.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 2. If data is not sent to the server due to network problem or other cause, the data will be backed up automatically and sent to the server again after network resumes to normal. Uploaded data format is as shown in position information of “immediately upload current position instruction” in GPRS mode and data status is AUTOLOW. 3.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 8. Emergency upload Description: Press SOS key for more than 3 seconds, and the device will operate as “instruction to immediately upload current position”; the status indicates SOS. At the same time, it will call the first prestored number. If it fails (the phone is turned off or cannot be connected), the second and the third phone number will be called in sequence.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker For example: #808#0000#24## Description: After receiving the instruction, TLT-1C will return confirmation message: START UPLOAD 24H HISTORICAL RECORD. It will send historical data recorded in the past 24 hours to the server with the same format as position information mentioned in “instruction to immediately upload current position” and information status is SOTRAGE.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 3. Default value is Greenwich time (UTC). 4. The instruction is available for data upload in GPRS mode only. Instruction set 1.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker 000+user password 001+user password monitor mode cutoff monitor mode open 003+user passwordE/Wxxxx.xxxxN/Syyyy.yyyyRzzz.z Fence scope setting(unit: degree, minute) 004+user passwordE/Waaa.aaaaaN/Sbb.bbbbbRzzz.z Fence scope setting(unit: degree,minute) 005+user passwordRzzz.z 006+user password,Gx,I/O,E/W+N/S,E/W+N/S 008+user password+Rzzz.
Instruction Manual V3.
Instruction Manual V3.
Instruction Manual V3.0 for TLT-1C GPS/GSM On-Vehicle Tracker Warranty The following after services are provided in order to serve and satisfy the customers: Ⅰ. Warranty scope: 1. The product may be replaced free of charge within 30 days since purchase in the event that it is ineligible when normal operation (man-made sabotage excluded) and without dismantlement. 2.