Specifications
Table Of Contents
- 1
- Applying development of unilateral communication
- Serial port intercommunication agreement
- Summarize
- Control command format of serial
- Set BaudRate
- Get Reader Version
- Set Relay
- Get Relay
- Set Output Power
- Set Frequency
- Read Param
- Set Param
- Read Auto Param
- Set Auto Param
- Select Antenna
- Restore factory settings
- Reboot
- Start/ stop automode
- Clear Memory
- Set Reader Time
- Get Reader Time
- Set Report Filter
- Get Report Filter
- Set Reader Network Address
- Get Reader Network Address
- SetReader MAC
- Get Reader MAC
- Report Now
- Get Tag Info.
- GetReaderID
- Command format of serial read-write tag
- Collection of operation command
- Electronic tag storage area and notes
- SDK software development
- SDK compose
- Design introduction
- Basic constant and figure
- Constant definition
- API function return code
- Data type definition
- Parameter figure in reader
- Function return code
- Control command function
- Connect reader
- Disconnection
- Set baud rate
- Read version
- Set output power
- Set operation frequency
- Read reader basic operation parameter
- Set reader basic operation parameter
- Read reader auto parameter
- Set reader auto parameter
- Select antenna
- Set relay state in reader
- Reboot reader
- Set time
- Get time
- Get record
- Delete all records
- Network command
- Set IP address for reader
- Get IP address in reader
- Set reader MAC address
- Get reader MAC address
- Read write ISO18000-6B function
- Identify tag ID number
- Identify selected tag ID number
- Read data block
- Write data block
- Slow write data block
- Set write protection
- Read write protection
- Read write ISO18000-6C function
- Identify EPC number of ISO18000-6C tag
- Read a block data
- Write a block data
- Set read write protection state
- FCC警告语大于20cm(1)
Serial port intercommunication agreement | VI-88TR development handbook
『F0H 03H 09H address CheckSum』
32 bytes of parameter(1 parameter 1 byte):
Byte number Definition
1
Baud rate of serial, value: 00H~08H，
2
Transmit power, value: 20～33dbm.
3
Start point of transmitting microwave signal frequency,
value(default 7): 0~59
4
End point of transmitting microwave signal frequency,
value(default 59): 0~59
5
Null
6
Word mode of reader: 0-Auto
，
1-Command
7 RS485 address of reader: 0 and 255 is broadcast address
8 Max tags of once reading
9
Tag type: 01H－ISO18000-6B, 02H－EPCC1, 04H－
EPCC1G2
10
Tag reading duration time: RF emission duration time, only
valid for EM tag. 0－10ms, 1－20ms, 2－30ms, 3－40ms.
11
Reading times M
：
reader will execute the command for M
times when receiving reading command from host pc.
12 1:enable buzzer 0: disable buzzer
13
Reader IP address1
14
Reader IP address2
15
Reader IP address3
16
Reader IP address4
17
Reader port –high
18
Reader port –low
19 Reader mask1
20 Reader mask2
21 Reader mask3
22 Reader mask4
23
Reader address gateway1
24
Reader address gateway2
25
Reader address gateway3
26
Reader address gateway4
27
Reader MAC1
28
Reader MAC2
29 Reader MAC3
30 Reader MAC4
31 Reader MAC5
32 Reader MAC6
090909RevA|Page 22 of 97